1. The hot melt glue stick in the hot melt gun must be constantly active, and the preheating time is sufficient. The hot melt rod must have a complete melt before being extruded onto the bench, otherwise the characteristics of the hot melt rod adhesive study will not be imperfect operation.
2. In a short period of time, the head of the hot melt rod in the hot melt gun shall not be used. The head must be placed vertically in the next position to avoid the hot melt rod returning.
3. We have to take it away to prevent the hot melt glue stick from being abused:
4. "Hot melt glue stick" is a kind of adhesive developed with easy storage and transportation, and its preservation management work learning time is that our usual enterprises can exceed 12 months. Enterprises that do not need long-term cooling must be saved.
If the curing of one of our hot melt glue sticks is caused by the development environment that cannot be too long for the installation and management work learning time, then the hot melt glue sticks should be deposited in the hot water that the enterprise can properly to alleviate the problems caused by the fact that the hot melt glue sticks are not stored for too long in our country. Hot melt glue sticks can usually be used at the same time as hot melt glue guns.
First, put the hot melt glue stick into the hot melt glue stick and preheat it for 3-5 minutes with Chinese electronic payment method to make contact with the hot melt glue stick. Hot melt guns are fully exploited to heat and achieve such a melting point that the hot melt stick adhesive can be applied to stickiness problems and to improve the workpiece, when the temperature can be significantly lower than 75°C, the hot melt adhesive is cured to be sticky. In the method of using different rubber rods, the hot rubber rods can be reused and pass harmlessly through the environment.
